2026-08-10

Rear Seat Floor Panel Section

Correction code: 10101819402 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	REAR FLOOR SEAT PANEL
4	Countersunk Rivet, 4.8 mm Long
2	Countersunk Rivet, 4.8 mm Short
3	Rivet, 4.8 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Floor Panel - 2nd Row - Front (Remove and Replace).
Remove the Seat Assembly - 2nd Row - LH (With 2nd Row Bench Seats) (Remove and Install).
Remove the HV Battery (AWD) (Remove and Install).
Cut the new Rear Seat Floor Panel to make the new component.
Cut Line

Reference Line/Point
- A = 297 mm
- B = 209 mm
Remove a section of the original component.
or Factory SPRs
Cut Line

Reference Line/Point
- A = 268 mm
- B = 180 mm
Prepare for installation.

Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
or Countersunk Rivets, 4.8 mm Short
or Countersunk Rivets, 4.8 mm Long

or Rivets, 4.8 mm
- C = 11 mm
- D = 22 mm
- E = 111 mm
- F = 19 mm
- G = 140 mm
- H = 12 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.
Install the HV Battery (AWD) (Remove and Install).
Install the Seat Assembly - 2nd Row - LH (With 2nd Row Bench Seats) (Remove and Install).
Install the Floor Panel - 2nd Row - Front (Remove and Replace).