Spine Assembly
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | CENTER SPINE ASSY- (For vehicles built before Nov 29, 2017) CENTER SPINE ASSY- (For vehicles built on or after Nov 30, 2017) |
|
| 4 |
Flow Form Rivet S18
|
Tesla part number 1069329-00-A. |
| 6 |
Flow Form Rivet S48
|
Tesla part number 1069332-00-A. |
| 2 | Butyl Patch | Tesla part number 1045194-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the B-Pillar Header Upper.
- Remove the Rear Header Upper.
-
Remove the original component.
or 
Factory Spot Welds
or 
Factory SPRs
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
NoteIf the vehicle has additional holes for the updated Roof Applique: Install a butyl patch over the clip hole on the new Spine to prevent water ingress.
- Install the B-Pillar Header Upper.
- Install the Rear Header Upper.
