Front Shock Tower Reinforcement (RH) Vehicles Built After 10-17-16
Correction code:
10101007102
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | Reinforcement Shock Tower RH (RH Shock Tower Reinforcement – for vehicles built after October 17, 2016) | |
| 4 | Structural Rivet, 6.5 mm Medium , M6x18 | Tesla part number 1006529-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Support Beam - Condenser (Remove and Replace).
- Remove the Compressor - Air Suspension (Remove and Replace).
- Remove the Forward Junction Box (Remove and Replace).
- Remove the Brake Lines - 4 Tube Bundle - ABS to Wheels (Remove and Replace).
- Remove the Air Spring Module - Front - RH (Remove and Replace).
- Remove the Subframe Assembly - Front - 2nd Generation (RHD) (Remove and Replace).
- Remove the Drive Unit - Front (2nd Generation) (Remove and Install).
- Remove the Fender Assembly - Front - LH (Remove and Replace).
- Remove the Front Motor Mount (RH) Vehicles Built Through October 15, 2016.
-
Remove the RH Motor Mount. Refer to the correct procedure for the vehicle
being repaired:
-
Remove the original component.
or Factory Structural Rivets
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the RH Motor Mount. Refer to the correct procedure for the vehicle
being repaired:
- Perform any necessary post-repair operations.
- Install the Front Motor Mount (RH) Vehicles Built Through October 15, 2016.
- Install the Fender Assembly - Front - LH (Remove and Replace).
- Install the Drive Unit - Front (2nd Generation) (Remove and Install).
- Install the Subframe Assembly - Front - 2nd Generation (RHD) (Remove and Replace).
- Install the Air Spring Module - Front - RH (Remove and Replace).
- Install the Brake Lines - 4 Tube Bundle - ABS to Wheels (Remove and Replace).
- Install the Forward Junction Box (Remove and Replace).
- Install the Compressor - Air Suspension (Remove and Replace).
- Install the Support Beam - Condenser (Remove and Replace).