Rear Rail End Plate
Correction code:
10101806502
10101806602
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY-PLATE-MX BUMPER MTG RR (Rear Rail End Plate) | |
| 4 | Bolt, hex-head , HF M10x1.50x25 [10.9]-G720 | Tesla part number 2007116. |
| 1 | Bolt, hex-head , M8-1.25x16 | Tesla part number 1005582-00-A. |
| 1 | Nut | Tesla part number 2007088. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Bumper Assembly - Rear (Remove and Replace).
- Remove the Absorber - Wheelhouse - Rear - RH (Remove & Replace).
- Remove the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Remove the Trim - Liftgate Trough - LH (Remove and Replace).
- Remove the MXP2 BODY - Bumper and Fascia - Rear Bumper Fascia - Rear Wing Bracket - LH (RR).
- Remove the MXP2 BODY - Bumper and Fascia - Rear Bumper Fascia - Rear Fascia Center Bracket (RR).
- Remove the MXP2 THERMAL MANAGEMENT - Cabin HVAC - Passenger Ducting and Vents - Air Extractor Assembly Mid - LH (RR).
-
Remove the Rear Panel Assembly.
-
Remove the original component.
or Factory Structural Rivets
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolts as follows:
- Tesla part number 2007116: 48 Nm.
- Tesla part number 1005582-00-A: 25 Nm.
-
If the vehicle was originally equipped with Rear Bumper Plate Shims,
install new Rear Bumper Plate Shims.
-
Install the Rear Panel Assembly.
- Perform any necessary post-repair operations.
- Install the MXP2 THERMAL MANAGEMENT - Cabin HVAC - Passenger Ducting and Vents - Air Extractor Assembly Mid - LH (RR).
- Install the MXP2 BODY - Bumper and Fascia - Rear Bumper Fascia - Rear Fascia Center Bracket (RR).
- Install the MXP2 BODY - Bumper and Fascia - Rear Bumper Fascia - Rear Wing Bracket - LH (RR).
- Install the Trim - Liftgate Trough - LH (Remove and Replace).
- Install the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Install the Absorber - Wheelhouse - Rear - RH (Remove & Replace).
- Install the Bumper Assembly - Rear (Remove and Replace).