Trunk Waterfall
Correction code:
10101807102
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | PNL,TRUNK,WATERFALL | |
| 9 | Structural Bulb Rivet, 6.5 mm | Tesla part number 1063943-00-A. |
| 3 | Rivet, 4.8 mm | Tesla part number 1028719-00-A. |
| 3 | SPR, 5x4 | Tesla part number 1026936-00-A. |
| 19 | SPR, 5x4.5 | Tesla part number 1026938-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Bracket - C-Pillar - Lower Zone - LH (Remove and Replace).
- Remove the Racetrack Trim - Lower - LH (Remove and Replace).
- Remove the Racetrack Trim - Rear - LH (Remove and Replace).
- Remove the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Remove the Absorber - Wheelhouse - Rear - RH (Remove & Replace).
- Remove the Seat Assembly - 3rd Row (Remove and Replace).
- Remove the Fascia Assembly - Rear (Remove and Install).
- Remove the Subframe Assembly - Rear (Remove and Install).
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
or Structural Bulb Rivets, 6.5 mm
- A = 457 mm
- B = 90 mm
- C = 9 mm
or SPRs, 5x4
NoteThe following Tesla SPR die is required to install this SPR: KA 075 2113.or SPRs, 5x4.5
NoteThe following Tesla SPR die is required to install this SPR: KA 075 2113. - Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Subframe Assembly - Rear (Remove and Install).
- Install the Fascia Assembly - Rear (Remove and Install).
- Install the Seat Assembly - 3rd Row (Remove and Replace).
- Install the Absorber - Wheelhouse - Rear - RH (Remove & Replace).
- Install the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Install the Racetrack Trim - Rear - LH (Remove and Replace).
- Install the Racetrack Trim - Lower - LH (Remove and Replace).
- Install the Bracket - C-Pillar - Lower Zone - LH (Remove and Replace).