Body Side Seal Baffle
Correction code:
10102903702
10102903902
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | BODYSIDE SEAL BAFFLE | |
| 5 | Rivet, 4.8 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Hinge - Door - Front - Lower - LH (Remove & Replace).
- Remove the Hinge - Door - Front - Upper - LH (Remove & Replace).
- Remove the Fender Assembly - Front - LH (Remove and Replace).
- Remove the Seal - Primary - Rear Door - LH (Remove and Replace).
- Remove the Seal - Primary - Front Door - LH (Remove and Replace).
- Remove the Door Assembly - Front - LH (Remove and Install).
- Remove the Hood Assembly (Remove and Install).
- Remove the Trim - B-Pillar - Lower - LH (Remove and Replace).
- Remove the Trim - A-Pillar - Lower - LH (Remove and Replace).
- Remove the Racetrack Trim - Front - LH (Remove and Replace).
- Remove the Brightwork - Upper - Front - LH (Remove and Replace).
- Remove the Carrier - Rocker Panel - LH (Remove and Replace).
- Remove the Applique - Roof - Front (Remove and Replace).
- Remove the Body Side Outer.
- Remove the Body Side Outer.
-
Remove the Body Side Outer.
-
Remove the original component.
or Factory Structural Rivets
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the Body Side Outer.
- Perform any necessary post-repair operations.
- Install the Body Side Outer.
- Install the Body Side Outer.
- Install the Applique - Roof - Front (Remove and Replace).
- Install the Carrier - Rocker Panel - LH (Remove and Replace).
- Install the Brightwork - Upper - Front - LH (Remove and Replace).
- Install the Racetrack Trim - Front - LH (Remove and Replace).
- Install the Trim - A-Pillar - Lower - LH (Remove and Replace).
- Install the Trim - B-Pillar - Lower - LH (Remove and Replace).
- Install the Hood Assembly (Remove and Install).
- Install the Door Assembly - Front - LH (Remove and Install).
- Install the Seal - Primary - Front Door - LH (Remove and Replace).
- Install the Seal - Primary - Rear Door - LH (Remove and Replace).
- Install the Fender Assembly - Front - LH (Remove and Replace).
- Install the Hinge - Door - Front - Upper - LH (Remove & Replace).
- Install the Hinge - Door - Front - Lower - LH (Remove & Replace).