2026-08-09

Buckle - 2nd Row - Center (5 Seat) (Remove and Replace)

Correction code 20057202 0.30 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2024-11-26: Add a note to clarify that harness should not be around bolt when install the buckle to seat cushion frame.
Equipment:
  • 2152873-00-A Tool, Inductive Heating

Torque Specifications

Table 1. Torque Specifications: Buckle - 2nd Row - Center (5 Seat) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the center buckle to the LH lower seat cushion frame
40 Nm (29.5 lbs-ft)
  • Torx T50 socket
 Replace

Remove

  1. Open all doors and fully lower all windows.
  2. Remove the 2nd row seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace)
  4. Remove the RH lower C-pillar trim. See .
  5. Remove the RH 2nd row seat back / seat frame assembly. See Seat Back - 2nd Row - RH (Remove and Replace).
  6. Remove the clip that attaches the center buckle connector to the LH lower seat cushion frame.
  7. Remove the center buckle connector from the LH seat frame harness.
  8. Remove the bolt that attaches the center buckle to the LH lower seat cushion frame, and then remove the center buckle from the assembly.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket

Install

  1. Position the LH center 2nd row buckle in to the vehicle, and then install the bolt that attaches the buckle to the seat cushion frame.
    40 Nm (29.5 lbs-ft)
    Note
    Make sure to not pinch the wire between the bolt and the buckle bracket. Harness should not be around bolt..
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  2. Connect the center buckle connector to the LH seat frame harness.
  3. Install the clip that attaches the center buckle connector to the LH lower seat cushion frame.
  4. Install the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
  5. Install the RH lower C-pillar trim. See .
  6. Install the 2nd row seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  7. Raise all windows and close all doors