2026-08-09

Seat Back - 2nd Row - RH (Remove and Replace)

Correction code 13054102 0.30 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2024-07-25: Added a note for NA vehicles to remind that the seat covers without ISOFIX flag for child locks must be replaced.

Torque Specifications

Tabella 1. Torque Specifications: Seat Back - 2nd Row - RH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the RH seat back lower frame to the vehicle
37 Nm (27.3 lbs-ft)
  • 11 mm socket
Replace
Avvertenza
Bolts must be installed in the following sequence:
  1. Front Outboard
  2. Rear Inboard
  3. Rear Outboard
  4. Front Inboard

Remove

  1. Remove the RH lower C-pillar trim. See .
  2. Release the clips that attach the main carpet to the lower seat cushion frames.
  3. Remove the bolts (x4) that attach the RH 2nd row seat back frame to the vehicle.
    Suggerimento
    Use of the following tool(s) is recommended:
    • 11 mm socket
    Suggerimento
    The two frontmost bolts are behind the main carpet.
  4. Carefully fold down the RH 2nd row seatback.
    Avvertenza
    Place a protective covering on the seat back upholstery and take care not to damage the upholstery during removal of the seat back.
    Avvertenza
    Do not place any additional weight on the seatback. Doing so may damage the seat frame alignment tabs, which can cause unevenness between the 60 and 40 seatbacks.
  5. Disconnect the electrical harness from the connector at the RH lower seat frame.
  6. With assistance, carefully remove the RH 2nd row seat back assembly from the vehicle.
    Avvertenza
    Place the seat back assembly in an area where it will not be tipped over or otherwise damaged.
    Nota
    For NA only: If the 2nd row seat that is not being replaced does not have ISOFIX flag for child locks, replace the seat cover. See .

Install

Installation procedure is the reverse of removal, except for the following:

Note
If the new seat back comes without the RH seatbelt buckle, install a new buckle to it. See .
CAUTION
The RH seat frame bolts must be installed in the following sequence:
  1. Front Outboard
  2. Rear Inboard
  3. Rear Outboard
  4. Front Inboard