2026-08-09

Panel Assembly - Rear (Remove and Replace)

Correction code 10102302 1.02 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Torque Specifications

Table 1. Torque Specifications: Panel Assembly - Rear (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the rear end panel to the body
10 Nm (7.4 lbs-ft)
  • 10 mm socket
 Reuse
Bolt that attaches the Bluetooth passive entry module to the rear fascia center bracket
3.5 Nm (2.6 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Remove the LH and RH taillights. See .
  2. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  3. Remove the bolt and release the tab that attach the Bluetooth passive entry module to the rear fascia center bracket, and then set the harness aside.
    Note
    When releasing the module from the bracket, rotate the LH side away from the bracket to release the tab.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Remove the center rear bracket. See .
  5. Remove the rear bumper beam or the trailer hitch assembly (if applicable). See Bumper Beam - Rear (Remove and Replace) or .
  6. Remove the lower trunk assembly. See Trunk Assembly - Lower (Remove and Replace).
  7. Lift the rear primary seal from the rear end panel.
  8. Remove the bolts that attach the rear end panel to the body.
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
  9. Remove the rear end panel from the vehicle.
    Note
    Slide the rear end panel rearward to free the panel from body.

Install

  1. Position the rear end panel from the vehicle.
    Note
    Align the panel with the body studs.
  2. Install the bolts that attach the rear end panel to the body.
    10 Nm (7.4 lbs-ft)
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Seat the rear primary seal onto the rear end panel.
  4. Install the lower trunk assembly. See Trunk Assembly - Lower (Remove and Replace).
  5. Install the rear bumper beam or the trailer hitch assembly (if applicable). See Bumper Beam - Rear (Remove and Replace) or .
  6. Install the center rear bracket. See .
  7. Install the bolt and tab that attach the Bluetooth passive entry module to the rear fascia center bracket.
    3.5 Nm (2.6 lbs-ft)
    Note
    Rotate the left side inward to install the tab.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  8. Install the rear fascia. See Fascia - Rear (Remove and Install).
  9. Install the LH and RH taillights. See .