2026-08-09

Trunk Assembly - Lower (Remove and Replace)

Correction code 15247002 0.24 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Torque Specifications

Table 1. Torque Specifications: Trunk Assembly - Lower (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the rear diffuser to lower trunk assembly
4 Nm (2.9 lbs-ft)
  • 10 mm deep socket
Reuse
Corner bolts that attach the lower trunk assembly to the vehicle
30 Nm (22.1 lbs-ft)
  • 13 mm deep socket
Reuse
Middle bolt that attach the lower trunk assembly to the vehicle
10 Nm (7.4 lbs-ft)
  • EP 14 socket
 Replace 1098835-00-B

Remove

  1. Remove the bolts that attach the rear diffuser to lower trunk assembly.
    4 Nm (2.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
  2. Remove the rear trunk carpet. See Tub - Rear Trunk (Remove and Replace).
  3. Remove the corner bolts that attach the lower trunk assembly to the vehicle.
    30 Nm (22.1 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm deep socket
  4. Remove and discard the middle fastener that attaches the lower trunk assembly to the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • EP 14 socket
  5. Remove the lower trunk assembly from the vehicle.
    Note
    For 7-seater vehicles, start by pulling straight up, and then tilt the rear of the assembly upwards to clear the 3rd row seats before pulling the assembly outwards.
    Figure 1. 7-seater

Install

Installation procedure is the reverse of removal, except for the following:

  • Apply Loctite 222 onto rear diffuser bolts when installing the rear diffuser to the lower trunk assembly.