2026-07-15

Wiper Module (Remove and Replace)

Correction code 17502502 0.30 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2026-05-13: Added warning about pinch points on wiper module.
  • 2023-11-29: Added software reinstall step to installation section.
  • 2023-07-03: Added wiper replacement procedure to installation section.
  • 2023-06-06: Removed configuration change.

Torque Specifications

Table 1. Torque Specifications: Wiper Module (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the wiper module to the vehicle
7 Nm (5.2 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  2. Remove the bolts that attach the wiper module to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Carefully pull the wiper module towards the front of the vehicle to release the rubber anchor from the bracket on the bulkhead.
  4. Rotate the wiper module, and then disconnect the electrical connector from the wiper module.
  5. Remove the wiper module from the vehicle.

Install

  1. With the wiper module facing upside down, connect the electrical connector. Afterwards, rotate the wiper module towards the rear of the vehicle to ensure proper harness clearance.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Keep your fingers away from any potential pinch points and moving parts while connecting and installing the wiper module. Do not attempt to test the module until it is fully installed in the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Check the harness to make sure it is not routed incorrectly.
  2. Carefully push the wiper module towards the rear of the vehicle so that the rubber anchor inserts into the bracket on the bulkhead.
  3. Install the bolts that attach the wiper module to the vehicle.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Install the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  5. Enable Service Mode through the touchscreen. See .
  6. Perform a software reinstall. See .
  7. Run the Wiper Replacement procedure: on the touch screen, touch Service > Closures > Windows > Wiper replacement, touch Run, and allow the routine to complete.
  8. Verify the operation of the windshield washers and wipers.