2026-08-13

Seal - Header - LH (Remove and Replace)

Correction code 11702102 0.24 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2026-08-13: Added notes to verify that the primary seal is installed behind the header seal.

Remove

  1. Open the LH front and rear doors and lower the LH front and rear windows.
  2. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  3. Partially release the LH front primary body seal from the vehicle to gain access to the header seal.
    Note
    Start from the upper corner closest to the B-pillar applique, and then pull straight down along the length of the seal to fully release the seal from the upper brightwork.
  4. Partially release the LH rear primary body seal from the vehicle to gain access to the header seal.
    Note
    Start from the upper corner closest to the B-pillar applique, and then pull straight down along the length of the seal to fully release the seal from the upper brightwork.
  5. Remove the LH B-pillar applique. See
  6. Release the clip that attaches the LH header seal to the LH upper bright trim cap, and then pull down to release the remaining portion of the seal.
    Note
    Start from the middle A-pillar and work rearward.

Install

  1. Position the LH header seal onto the vehicle, and then fasten clip that attaches the seal to the LH A-pillar.
  2. Install the remaining portion of the LH header seal.
    Note
    Start from the middle A-pillar and work rearward.
  3. Install the LH B-pillar applique. See
  4. Starting from the upper rear corner, install the LH rear primary body seal to the vehicle.
    Note
    The seal edge should not be visible.
    Note
    Make sure the seal fully engages the brightwork.
    Note
    Make sure that the primary seal is installed behind the header seal.
  5. Starting from the upper rear corner, install the LH front primary body seal onto the LH upper brightwork.
    Note
    The seal edge should not be visible.
    Note
    Make sure the seal fully engages the brightwork.
    Note
    Make sure that the primary seal is installed behind the header seal.
  6. Connect 12V power. See 12V/LV Power (Disconnect and Connect).
  7. Close the LH doors and lower the LH windows.