2026-08-09

Hinge - Door - Front - Lower - LH (Remove and Replace)

Correction code 11336602 0.18 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Apparecchiatura:
  • 1588903-00-A Body Gap and Flush Tool
  • 1079485-00-A Crowfoot Open End Set

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Use a jack to support the LH front door from the bottom.
    Nota
    Make sure to use soft material to protect the door paint.
  4. Apply masking tape to the area surrounding the LH front door lower hinge on the body and door to aid in alignment during installation.
  5. Remove the bolts (x2) that attach the LH front door lower hinge to the body.
    Suggerimento
    Use of the following tool(s) is recommended:
    • 13mm combination wrench
  6. Remove the bolt that attaches the LH front door lower hinge to the door.
    Suggerimento
    Use of the following tool(s) is recommended:
    • 13mm combination wrench
  7. Carefully remove the LH front door lower hinge from the vehicle.

Install

  1. Install the new LH front lower hinge.
  2. Hand-tighten the bolt that attaches the LH front door lower hinge to the door.
    Suggerimento
    Use of the following tool(s) is recommended:
    • 13mm combination wrench
  3. Hand-tighten the bolts (x2) that attach the LH front door lower hinge to the body.
    Suggerimento
    Use of the following tool(s) is recommended:
    • 13mm combination wrench
  4. Close the LH front door and check for gap and flushness. Adjust as necessary.
  5. Tighten the bolt that attaches the LH front door lower hinge to the door.
    49 Nm (36.1 lbs-ft)
    Suggerimento
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
  6. Tighten the bolts (x2) that attach the LH front door lower hinge to the body.
    24 Nm (17.7 lbs-ft)
    Suggerimento
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
  7. Remove the masking tape that surrounds the LH front door lower hinge on the body and door.
  8. Remove the support from the LH front door.
  9. Apply touch up paint to the LH front lower door hinge bolts as needed.
    Nota
    Make sure to shake touch up paint before applying, and wait at least 20 minutes to allow the 1st coat to completely dry before applying the 2nd coat (if necessary).
  10. Raise the LH front window.
  11. Close the LH front door.