2026-08-13

Seal - Body - Side - Rear - Primary - LH (Remove and Replace)

Correction code 11700502 0.06 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il relativo FRT associato, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2026-08-13: Added notes to verify that the primary seal is installed behind the header seal.
  • 2025-12-09: Added location of seal seam for vehicles built at Giga Berlin.
  • 2024-09-24: Update rear door primary seal install with new datum.
Equipment:
  • 1143801-00-A - LED UNDERHOOD LIGHT

Remove

  1. Open the LH rear door.
  2. Pull on the LH primary rear side body seal to release it from the body.
    Note
    Start in the corner closest to the B-pillar applique and pull straight down to release the upper portion of the trim first.

Install

  1. Position LH rear primary seal to LH B-pillar , and then press the seal into position working along the bright molding.
    Note
    Ensure the wider side of the seal is seated towards the interior of the vehicle.
    Note
    Make sure that the primary seal is installed behind the header seal.
    Figure 1. For vehicles built at Fremont and Austin, make sure the seam on the seal is even with the LH upper B-pillar.
    Figure 2. For vehicles built at Giga Shanghai, make sure the seam on the seal is even with the bottom of the LH lower B-pillar.
    Figure 3. For vehicles built at Giga factory Berlin, make sure the seam on the seal is even with the bottom of the LH lower C-pillar trim.
  2. Press the LH rear primary body seal into the LH C-pillar, and then work downward toward the B-pillar.
    Note
    If excess material forms along the seal, release the seal and disperse in opposite directions.
    Note
    Make sure that the primary seal is installed behind the header seal.
  3. Tuck the LH primary rear side body seal into the bright trim molding.
    Note
    Make sure that the seal is fitted properly to the trim panels and the headliner.
  4. Pull the seal strings from the new seal.
  5. Close LH rear door.