2026-07-31
Sensor - Crash Accelerometer - LH (Remove and Replace)
교정 코드
20201152
FRT
0.36
메모: 절차에서 명시적으로 언급하지 않는 한 위에 나열된 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오.
참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간의 내용을 참조하십시오.
메모: 아래 절차를 수행할 때 개인 보호의 내용을 참조하여 적절한 PPE를 착용했는지 확인하십시오.
참고: 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.
경고
이 절차는 초안입니다. 따라서 검증은 되었지만 경고 및 주의 사항이 누락되었을 수 있습니다. 고전압 시스템 및 구성 요소에서 또는 그 근처에서 작업하는 경우에는 안전 요구 사항을 준수하고 최고 수준의 주의를 기울여야 합니다.
- 2026-06-24: Released new procedure.
- Open the LH front door.
- Lower the LH front window.
-
Open the hood.
-
Power off the vehicle using the touchscreen.
-
Remove the rear underhood apron.
-
Disconnect the LV battery connector and First Responder Loop.
-
Remove the RH underhood apron.
-
Remove the LH underhood apron.
-
Remove the front underhood apron.
-
Remove the underhood storage unit access panel.
-
Remove the underhood storage unit carpet.
-
Remove the underhood storage unit from the vehicle.
-
Disconnect connector from shotgun accelerometer
참고1x connector, pull red locking tap
-
Removed bolt from sensor
참고1x bolt, 10mm, 7Nm
-
Remove shotgun accelerometer
참고1x tab
-
Install shotgun accelerometer
참고1x tab
-
Install bolt in sensor
참고1x bolt, 10mm, 7Nm
-
connect connector to shotgun accelerometer
참고1x connector, push red locking tap
-
Install the underhood storage unit.
-
Install the underhood storage unit carpet.
-
Install the underhood storage unit access panel.
-
Install the front underhood apron.
-
Install the LH underhood apron.
-
Install the RH underhood apron.
-
Connect the First Responder Loop and LV battery connector.
-
Install the rear underhood apron.
- Close the hood.
-
Calibrate LH and RH Falcon Wing doors from center display
참고Calibration required after LV system is powered down > Service > Calibrate Doors > Hold down Calibrate doors until doors cycle > Calibration Complete Message will appear
- Raise the LH front window.
- Close the LH front door.