2023-08-16

패널 - 에어로 실드 - 전면(탈거 및 교체)

Correction code 12030102 0.24 바고: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을(를) 참조하십시오. FRT 값에 대한 피드백을 제공하려면ServiceManualFeedback@tesla.com으로 이메일을 보내십시오. 참고: 아래 절차를 수행할 때 적절한 PPE를 착용했는지 확인하려면 개인 보호의 내용을 참조하십시오.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

탈거

  1. Raise and support the vehicle on a 2 post lift. See 차량 올리기 - 2 포스트 리프트.
  2. Release the push clips (x2) that attach the front aero shield panel to the LH and RH front wheel arch liners.
  3. Release the push clips (x3) that attach the front aero shield panel to the underbody.
  4. Remove the bolts (x9) that attach the front aero shield panel to the front subframe, and then remove the panel from the vehicle.

장착

  1. Apply a drop of Loctite 222 onto the threads of each front aero shield panel bolt.
  2. Install the front aero shield panel to the front subframe, and then install the bolts (x9) that attach the panel to the subframe.
    6 Nm (4.4 lbs-ft)
  3. Fasten the push clips (x3) that attach the front aero shield panel to the underbody.
  4. Fasten the push clips (x2) that attach the front aero shield panel to the LH and RH front wheel arch liners.
  5. Remove the vehicle from the lift. See 차량 올리기 - 2 포스트 리프트.