2025-11-06

Buckle - 2nd Row - Center (5 Seat) (Remove and Replace)

Correction code 20057202 0.30 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2024-11-26: Add a note to clarify that harness should not be around bolt when install the buckle to seat cushion frame.
Equipment:
  • 2152873-00-A Tool, Inductive Heating

Torque Specifications

Table 1. Torque Specifications: Buckle - 2nd Row - Center (5 Seat) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the center buckle to the LH lower seat cushion frame
40 Nm (29.5 lbs-ft)
  • Torx T50 socket
 Replace

Remove

  1. Open all doors and fully lower all windows.
  2. Remove the 2nd row seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace)
  4. Remove the RH lower C-pillar trim. See .
  5. Remove the RH 2nd row seat back / seat frame assembly. See Seat Back - 2nd Row - RH (Remove and Replace).
  6. Remove the clip that attaches the center buckle connector to the LH lower seat cushion frame.
  7. Remove the center buckle connector from the LH seat frame harness.
  8. Remove the bolt that attaches the center buckle to the LH lower seat cushion frame, and then remove the center buckle from the assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket

Install

  1. Position the LH center 2nd row buckle in to the vehicle, and then install the bolt that attaches the buckle to the seat cushion frame.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to not pinch the wire between the bolt and the buckle bracket. Harness should not be around bolt..
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  2. Connect the center buckle connector to the LH seat frame harness.
  3. Install the clip that attaches the center buckle connector to the LH lower seat cushion frame.
  4. Install the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
  5. Install the RH lower C-pillar trim. See .
  6. Install the 2nd row seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  7. Raise all windows and close all doors