2026-05-12

Seat Cushion - Lower - 2nd Row (Remove and Replace)

Correction code 13051002 0.12 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Os vídeos incluídos neste procedimento destinam-se a ser utilizados como uma visão geral apenas para efeitos complementares. Siga todos os passos enumerados no procedimento para evitar danos nos componentes e/ou ferimentos.

Remove

  1. Move the driver seat and the front passenger seat fully forward.
    Informational PurposesAn informational icon, calling your attention
    Note
    Note the position of the driver seat and the front passenger seat prior to movement so that both seats are restored to their original position during installation.
  2. Lift the front edge of the 2nd row lower seat cushion upward, and then rest the cushion against the 2nd row seat back.
  3. Disconnect the electrical connector on the LH side of the seat cushion, and then remove the seat cushion from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If performing additional procedures that require folding the second row seatback down with the lower cushion removed, do not place any additional weight on the seatbacks. Doing so may damage the seat frame alignment tabs, which can cause unevenness between the 60 and 40 seatbacks.
  4. Inspect the ancillary bay probe lid cover on the ancillary bay for the presence of a breather.
  5. If the breather is missing, install one now.
    Informational PurposesAn informational icon, calling your attention
    Note
    After installing the breather, if necessary, return to the procedure that required removal of the 2nd row lower seat cushion.

Install

  1. Position the seat cushion in the vehicle.
  2. Connect the electrical connector on the LH side of the seat cushion.
  3. Insert the seat belt buckles through the seat cushion holes.
  4. Slide the seat cushion rearwards, align the grooves in the foam with the seat rails, and then carefully push down on the cushion until it snaps onto the seat rails.
  5. Make sure that the seat cushion is fully seated with a push and pull test.
  6. Move the driver seat and the front passenger seat to their original position.