2026-05-22

Fascia - Rear - Upper (Remove and Replace)

Correction code 10012802 0.84 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2023-11-02: Added notes to distinguish between the steps for HW3/HW4 vehicles.

Torque Specifications

Table 1. Torque Specifications: Fascia - Rear - Upper (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x6) that attach the lower rear fascia to the upper rear fascia
3 Nm (2.2 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. For HW3 vehicles, release the connector locks (x2), and then disconnect the rear fascia harness connectors (x6).
    Informational PurposesAn informational icon, calling your attention
    Note
    Skip this step for HW4 vehicles.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not push down on the red locking tab. Pull the red tab to release the connector lock.
  3. For HW3 vehicles, remove the clips that attach the rear fascia harness to the upper rear fascia, and then remove the harness from the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Skip this step for HW4 vehicles.
  4. Remove the bolts (x6) that attach the lower rear fascia to the upper rear fascia.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Remove the metal clips from the center of lower rear fascia.
  6. Release the tabs (x17) that attach the upper rear fascia to the lower rear fascia, and then separate the upper rear fascia from the lower rear fascia.
  7. Remove the rear parking distance sensors from the upper rear fascia for HW3 vehicles. See #GUID-57298231-B4D9-4589-AD7C-E82BBC397FD7.
    Informational PurposesAn informational icon, calling your attention
    Note
    Skip this step for HW4 vehicles.

Install

Installation procedure is the reverse of removal.