2025-03-09

置物板加长板（前）

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	EXTN, PARCEL SHELF FRONT（置物板加长板 - 前）
1	ASY, PARCEL SELF RETRACTOR REIF（置物板卷收器）
5	Rivet, 4.8 mm
5	Structural Bulb Rivet, 6.5 mm
4	Countersunk Rivet, 4.8 mm Short
5	Flow Form Rivet S18

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

拆卸后围内件（面板）。
拆卸置物板加长板（后）。
Remove the original component.

or Factory Spot Welds

or Drill through factory spot welds
注
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
在 EXTN, PARCEL SHELF FRONT 和 ASY, PARCEL SELF RETRACTOR REIF 的接合面涂抹结构型粘合剂。
组装 EXTN, PARCEL SHELF FRONT 和 ASY, PARCEL SELF RETRACTOR REIF 来创建新组件。

or Countersunk Rivets, 4.8 mm Short

or Structural Bulb Rivets, 6.5 mm

or Flow Form Rivets, S18
Prepare for installation.

or Structural Bulb Rivets, 6.5 mm

or Rivets, 4.8 mm

or Flow Form Rivets, S18
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
安装置物板加长板（后）。
安装后围内件（面板）。
Perform any necessary post-repair operations.