2025-01-24

Power Strut - Liftgate (Remove and Replace)

Correction code 11334202 0.18 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2025-01-24: Deleted the trunk side trim and C-pillar steps according to the latest validation.
Equipment:
  • 1080562-00-A - Hood Prop
  • 1082502-00-A - Inflatable Air Bag

Remove

  1. Open the liftgate and the LH rear door.
  2. Position inflatable airbag between the rear headliner and the roof glass to access the power strut connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply tape to the headliner as needed.
  3. Disconnect the liftgate power strut connector.
  4. Release the tabs that attach the electrical harness grommet to the body, and then release the grommet from the body.
  5. Support the liftgate with a prop.
  6. Release the lower liftgate power strut ball stud that is attached to the vehicle.
  7. Release the upper liftgate power strut ball stud that is attached to the liftgate, and then remove the strut from the vehicle.

Install

  1. Clip the upper liftgate power strut ball stud to the liftgate.
  2. Clip the lower liftgate power strut ball stud to the vehicle.
  3. Route the electrical harness through the body, and then secure the grommet.
  4. Connect the liftgate power strut connector.
  5. Remove the inflatable airbag from between the rear headliner and the roof glass.
  6. Close the liftgate and the LH rear door.