2024-08-23

Accelerator (Remove and Replace)

Correction code 17551002 0.36 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  3. Remove the driver knee airbag. See .
  4. Remove the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Disconnect the electrical connector from the accelerator.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the connector locking tab is red, pull the red locking tab away from the pedal housing.
  6. Remove the bolt that attaches the accelerator to the body.
  7. Slide the accelerator downwards, and then remove the accelerator from the vehicle.

Install

  1. Slide the accelerator up, and then install the accelerator into the bracket.
  2. Install the bolt that attaches the accelerator to the body.
    7 Nm (5.2 lbs-ft)
  3. Connect the accelerator electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the connector locking tab is red: push the red locking tab towards the pedal housing.
  4. Install the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Install the driver knee airbag. See .
  6. Reconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  7. Connect a laptop with Toolbox 3 to the vehicle.
  8. Run the following Toolbox routines to confirm pedal operation:
    • TEST-SELF_PMR_X_CAN-COMMSvia Toolbox:(link)
  9. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).