2026-05-12

Seal - Body - Side - Rear - Primary - LH (Remove and Replace)

Correction code 11700502 0.06 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2025-12-09: Added location of seal seam for vehicles built at Giga Berlin.
  • 2024-09-24: Update rear door primary seal install with new datum.
Equipamento:
  • 1143801-00-A - LED UNDERHOOD LIGHT

Remove

  1. Open the LH rear door.
  2. Pull on the LH primary rear side body seal to release it from the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start in the corner closest to the B-pillar applique and pull straight down to release the upper portion of the trim first.

Install

  1. Position LH rear primary seal to LH B-pillar , and then press the seal into position working along the bright molding.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the wider side of the seal is seated towards the interior of the vehicle.
    Figure 1. For vehicles built at Fremont and Austin, make sure the seam on the seal is even with the LH upper B-pillar.
    Figure 2. For vehicles built at Giga Shanghai, make sure the seam on the seal is even with the bottom of the LH lower B-pillar.
    Figure 3. For vehicles built at Giga factory Berlin, make sure the seam on the seal is even with the bottom of the LH lower C-pillar trim.
  2. Press the LH rear primary body seal into the LH C-pillar, and then work downward toward the B-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    If excess material forms along the seal, release the seal and disperse in opposite directions.
  3. Tuck the LH primary rear side body seal into the bright trim molding.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the seal is fitted properly to the trim panels and the headliner.
  4. Pull the seal strings from the new seal.
  5. Close LH rear door.