Rear Quarter Outer (Lower) (Vehicles Built Through February 17, 2022)
Correction code:
10100125702
10100125802
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | PANEL - REAR QUARTER OUTER EXTENSION (Rear Quarter Outer - Lower) | |
| 7 | Structural Bulb Rivet, 6.5 mm | |
| 4 | Rivet, 4.8 mm | |
| 16 | Flow Form Rivet S08 | |
| 2 | Flow Form Rivet S18 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or Factory Spot Welds
or Drill through factory spot welds
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Fill the gap between the Quarter Outer panel and the Quarter Outer Lower panel
(indicated in red) with urethane.
- After the urethane has cured, use seam sealer to completely fill the seam between the Quarter Outer panel and the Quarter Outer Lower panel.
- Perform any necessary post-repair operations.