• The Repair Procedure section of this procedure contains information necessary to replace the rear section of the Wheelhouse Outer. If replacing the complete Wheelhouse Outer (not the rear section of the Wheelhouse Outer), use the Wheelhouse Outer (Complete) (Vehicles Built Through February 17, 2022) procedure.
• Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
• This procedure can be completed without using a frame bench.

Quantity	Description	Image / Notes
1	WHEEL ARCH OUTER PANEL (Wheelhouse Outer)
5	Structural Bulb Rivet, 6.5 mm
1	Flow Form Rivet S28

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

• It is allowable to cut through a clearance hole or a non functional hole (exterior trim hole), as described below.
• Do not cut within 25 mm. of the center of a stud.
• Sections do not require fasteners at butt or overlap joints unless specifically indicated.
• Gaps between panels of overlaid and butt joints should be as small as possible to maximize joint strength.
• Seal all open seams.