Cowl Top (Vehicles Built Through November 20, 2021)
Correction code:
10101005202
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Verify This is the Correct Repair Procedure
- Through November 19, 2021, use this repair procedure.
- On November 20,
2021:
- Remove any components necessary to view the portion of the original Cowl Side Assembly that is attached to the Cowl Top.
- If the Cowl Top
is attached to the Cowl Side Assembly as shown below:
Use this repair procedure – Cowl Top (Vehicles Built Through November 20, 2021). Do not use this repair procedure. Instead, use the Cowl Top (Vehicles Built On or After November 20, 2021) repair procedure.
- After November 20, 2021, use the Cowl Top (Vehicles Built On or After November 20, 2021) repair procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY - COWL TOP (Cowl Top) | |
| 2 | High Strength Structural Rivet, 6.5 mm | |
| 12 | Structural Bulb Rivet, 6.5 mm | |
| 4 | High Strength Structural Flange Rivet, 6.5 mm | |
| 11 | Flow Form Rivet S08 | |
| 3 | Flow Form Rivet S48 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
or High Strength Structural Rivets, 6.5 mm
or Structural Bulb Rivets, 6.5 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.