Battery Flow Nut Replacement (Rear Crossmember)
Correction code:
Pending
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | NUT,REC,M8,[10],G0110,T02,BLUE (Square Nut) | |
| 1 | HV BATTERY NUT STRIP (Nut Strip) |
Note If the original Nut Strip is
not damaged, it can be reused. |
| 2 | Pop Rivets | |
| 1 | BUTYL FOIL PATCH 50x50x1mm | Tesla part number 1045194-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Cut an access window on the bottom of
the crossmember.
Cut Line
Reference Line/Point
- A = 115 mm
- B = 80 mm
- C = 82 mm
- D = 105 mm
-
Remove the factory rivets in
the repair area.
or Factory Structural Rivets
-
Remove the Nut Strip through the
access window.
NoteIf the original Nut Strip is not damaged, it can be reused.
- Remove the Battery Flow Nut from the Nut Strip.
- Install the Battery Flow Nut on the Nut Strip.
- Install the Nut Strip through the access window.
-
Install fasteners through the
crossmember and the Nut Strip.
or Pop Rivets
- Apply an anti-corrosion coating to any bare metal.
-
Install a butyl patch over the access window.
- Perform any necessary post-repair operations.