Cowl Side Assembly (Vehicles Built On or After November 20, 2021)
Correction code:
10100109802
10100111302
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Verify This is the Correct Repair Procedure
- After November 20, 2021, use this repair procedure.
- On November 20,
2021:
- Remove any components necessary to view the portion of the original Cowl Side Assembly that is attached to the Cowl Top.
- If the Cowl Top
is attached to the Cowl Side Assembly as shown below:
Bolts in the highlighted area: Use this repair procedure – Cowl Side Assembly (Vehicles Built On or After November 20, 2021). No bolts in the highlighted area: Do not use this procedure. Instead, use the Cowl Side Assembly (Vehicles Built Through November 20, 2021) repair procedure.
- Through November 19, 2021, use the Cowl Side Assembly (Vehicles Built Through November 20, 2021) repair procedure.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | SUB-ASSY - COWL SIDE SX (Cowl Side Assembly) |
![]() |
17 |
![]() |
|
2 |
![]() |
|
2 |
![]() |
Tesla part number 1006529-00-A. |
1 |
![]() |
Tesla part number 1022448-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Hinge Pillar Assembly.
-
Remove the original component.
or
Drill through factory spot welds
NoteWhen drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.or
Bolts
- Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the fasteners as follows:
-
Bolt bolts, part number 1006529-00-A: 12 Nm.
-
Bolt, Torx-head bolt, part number 1022448-00-A: 30 Nm.
-
- Install the Hinge Pillar Assembly.
- Perform any necessary post-repair operations.