2026-08-10

Rear Motor Cover Floor

Correction code: 10101818202 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASY, MOTORBAY COVER (Rear Motor Cover)
16	High Strength Structural Rivet, 6.5 mm
8	Structural Bulb Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Seat Back - 2nd Row - LH (Remove and Replace).
Remove the Seat Back - 2nd Row - RH (Remove and Replace).
Remove the Insulator - Motor Bay - Front (Remove and Replace).
Remove the Trim - Side - Trunk - RH (Remove and Replace).
Remove the Trim - Side - Trunk - LH (Remove and Replace).
Remove the Insulator - Motor Bay - Rear (Remove and Replace).
Remove the NVH Insulator - Floor - Rear Trunk (Remove and Replace).
Remove the Brake Lines - Rear - LH to Sill (Remove and Replace).
Remove the Brake Lines - Rear - RH to Sill (Remove and Replace).
Remove the original component.

or Factory Spot Welds
Prepare for installation.
or High Strength Structural Rivets, 6.5 mm
- A = 260 mm
- B = 15 mm
- C = 21 mm
- D = 13 mm
or Structural Bulb Rivets, 6.5 mm
- E = 229 mm
- F = 13 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.
Install the Brake Lines - Rear - RH to Sill (Remove and Replace).
Install the Brake Lines - Rear - LH to Sill (Remove and Replace).
Install the NVH Insulator - Floor - Rear Trunk (Remove and Replace).
Install the Insulator - Motor Bay - Rear (Remove and Replace).
Install the Trim - Side - Trunk - LH (Remove and Replace).
Install the Trim - Side - Trunk - RH (Remove and Replace).
Install the Insulator - Motor Bay - Front (Remove and Replace).
Install the Seat Back - 2nd Row - RH (Remove and Replace).
Install the Seat Back - 2nd Row - LH (Remove and Replace).