Rear Node Upper Reinforcement (Front)
Correction code:
10101817902
10101817802
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY PNL MLDS P1P2 CLOSEOUT (Rear Node Upper Reinforcement – Front) | |
| 10 | ||
| 1 | Structural Bulb Rivet, 6.5 mm | |
| 3 | Flow Form Rivet S28 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Seat Back - 2nd Row - LH (Remove and Replace).
- Remove the Seat Back - 2nd Row - RH (Remove and Replace).
- Remove the Retractor - Seatbelt - 2nd Row - LH (Remove and Replace).
- Remove the Busbars - Charge Port to HV Battery (Remove and Replace).
- Remove the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Remove the Insulator - Motor Bay - Rear (Remove and Replace).
- Remove the Wheel Arch Liner - Rear - LH (Remove and Replace).
- Remove the Seat Back - 2nd Row - LH (Remove and Replace).
- Remove the Seat Back - 2nd Row - RH (Remove and Replace).
- Remove the Retractor - Seatbelt - 2nd Row - LH (Remove and Replace).
- Remove the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
- Remove the Insulator - Motor Bay - Rear (Remove and Replace).
- Remove the Wheel Arch Liner - Rear - LH (Remove and Replace).
-
Remove the original component.
or RIVTAC
or Factory Spot Welds
-
Prepare for installation.
or High Strength Structural Rivets, 6.5 mm
- A = 11 mm
- B = 12 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Wheel Arch Liner - Rear - LH (Remove and Replace).
- Install the Insulator - Motor Bay - Rear (Remove and Replace).
- Install the Insulator - Wheelhouse - Rear - RH (Remove and Replace).
- Install the Retractor - Seatbelt - 2nd Row - LH (Remove and Replace).
- Install the Seat Back - 2nd Row - RH (Remove and Replace).
- Install the Seat Back - 2nd Row - LH (Remove and Replace).
- Install the Wheel Arch Liner - Rear - LH (Remove and Replace).
- Install the Insulator - Motor Bay - Rear (Remove and Replace).
- Install the Insulator - Wheelhouse - Rear - LH (Remove and Replace).
- Install the Busbars - Charge Port to HV Battery (Remove and Replace).
- Install the Retractor - Seatbelt - 2nd Row - LH (Remove and Replace).
- Install the Seat Back - 2nd Row - RH (Remove and Replace).
- Install the Seat Back - 2nd Row - LH (Remove and Replace).