Rear Rail End Plate
Correction code:
10101805702
10101805802
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY-PLATE-MX BUMPER MTG RR LH-SVC (Rear Rail End Plate - LH) |
Note Order only when replacing the
LH component. |
| 1 | ASY-PLATE-MX BUMPER MTG RR LH-SVC (Rear Rail End Plate - RH) |
Note Order only when replacing the RH
component. |
| 4 per end plate being replaced |
Bolt , HF M10x1.50x25 [10.9]-G720 |
Tesla part number 2007116. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the Rear Panel Assembly (Vehicles Built Through May 21, 2024).
-
Remove the original component.
or Bolts
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
or Bolts
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
Torque the bolts to 48 Nm.
-
Install the Rear Panel Assembly (Vehicles Built Through May 21, 2024).
- Perform any necessary post-repair operations.