26/09/2024 17:49:40

Cantrail Inner Extension

Repair Procedure

  1. Remove the Roof Rail Outer.
  2. Remove the Rear Header Lower.
  3. Remove the original component.

    or Factory SPRs

    or Factory Spot Welds

    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  4. Prepare for installation.
  5. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  6. Install the new component or components.
  7. Install the Rear Header Lower.
  8. Install the Roof Rail Outer.
  9. Install the Coat Hook Clip Bracket.
  10. Install the fasteners as indicated.
    or Flow Form Rivets, S28

    or Flow Form Rivets, S38

    or Flow Form Rivets, S48

    Informational PurposesAn informational icon, calling your attention
    Note
    These flow form rivets replace the original three spot welds that joined the Divider Bar, the Cantrail Extension, and the Roof Rail Outer.
  11. Perform any necessary post-repair operations.