03/07/2024 16:10:12

Rear Quarter Inner Assembly

Parts List

Quantity Description Image / Notes
1 MY Asy, Rear Quarter Inner, SVC E-COAT (Rear Quarter Inner Assembly)
15 High Strength Structural Rivet, 6.5 mm
4 Structural Bulb Rivet, 6.5 mm
3 Rivet, 4.8 mm
6 Flow Form Rivet S48
2 Flow Form Rivet S38

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the necessary portion of the Body Side Outer to expose the underlying component being replaced.
  2. Remove the Dogleg Lower.
  3. Remove the Roof Rail Outer.
  4. Remove the original component.

    or Factory Spot Welds

    or Drill through factory spot welds

  5. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    In the images below, the red X indicates a location where a previously installed fastener is not being replaced.

    or High Strength Structural Rivets, 6.5 mm

    or Rivets, 4.8 mm

    or Structural Bulb Rivets, 6.5 mm

    or Flow Form Rivets, S48

    or Installation Spot Welds

    • A = 81 mm
    • B = 16 mm
  6. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  7. Install the new component or components.
  8. Perform resistance spot welding.

    or Installation Spot Welds

    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  9. Install the Roof Rail Outer.
  10. Install the Dogleg Lower.
  11. Install the portion of the Body Side Outer that was removed to expose the component being replaced.
  12. Install the fasteners as indicated.
  13. Perform any necessary post-repair operations.