Sill Inner Extension (Vehicles Built Through September 17, 2024)
Correction code:
10100133102,
10100116402
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | MY EXTN, SILL INNER LWR SVC E-COATED (Sill Inner Extension) | |
| 1 | or Structural Countersunk Rivets, 6.5 mm | |
| 1 | Flow Form Rivet S38 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the Wheelhouse Extension (Front).
-
Remove the necessary portion of the
Door Ring Inner.
-
Remove the original component.
- or Factory SPRs
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
- or Structural Countersunk Rivets, 6.5 mm
- Reference Line/Point
- or Flow Form Rivets, S38 A = 26 mm B = 85 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the necessary portion of the
Door Ring Inner.
-
Install the Wheelhouse Extension (Front).
- Perform any necessary post-repair operations.