2026-06-12

Rear Quarter Outer

Correction code: 10101916602, 10101916702 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	MY Rear Quarter Outer Rr,RH SVC E-COATED (Rear Quarter Outer)
16	Structural Bulb Rivet, 6.5 mm
1	Flow Form Rivet S18
5	Flow Form Rivet S38

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Wheelhouse Insulator - Rear - RH (Remove and Replace).
Remove the Insulator - Wheelhouse - LH (Remove and Replace).
Remove the Busbars - Charge Port to HV Battery (Remove and Replace).
LH component only: Remove the CP ECU Support Bracket.
Remove the Dogleg Lower.
Remove the original component.
- or Factory SPRs
- or Factory Spot Welds
Remove the original component.
- or Factory SPRs
- or Factory Spot Welds
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced.
- or Structural Bulb Rivets, 6.5 mm
- or Flow Form Rivets, S18
Prepare for installation.
- or Structural Bulb Rivets, 6.5 mm
Prepare for installation.
- or Structural Bulb Rivets, 6.5 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the Dogleg Lower.
LH component repair only: Install the CP ECU Support Bracket.
Install the fasteners as indicated.
- or Flow Form Rivets, S38
Perform any necessary post-repair operations.
Install the Busbars - Charge Port to HV Battery (Remove and Replace).
Install the Insulator - Wheelhouse - LH (Remove and Replace).
Install the Wheelhouse Insulator - Rear - RH (Remove and Replace).