13/08/2024 19:44:05

Front Floor Extension

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.
    or Countersunk Rivets, 4.8 mm Long
    • A = 263 mm.
    • B = 210 mm.
    • C = 158 mm.
    • D = 105 mm.
    • E = 11 mm.

    or Countersunk Rivets, 4.8 mm Short

    or High Strength Structural Rivets, 6.5 mm

  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.