Liftgate Ball Stud Nut
Correction code:
Pending
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- This repair is only to be performed if the Liftgate Ball Stud Nut has become detached from the Body Side Outer.
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
|
1 |
WELD NUT - HF - M8 - STL[10] |
Tesla part number 1077796-00-A. |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Ball Stud - Liftgate - Body Side - Pair (Remove and Replace).
-
Remove the original component.
- GMA Weld
-
If necessary, straighten the trough.
NoteRefer to Body Structure Materials and Allowed Operations for information about approved methods for straightening the trough.
- Install and hand tighten a bolt into the weld nut.
- Apply a small amount of structural adhesive to the flat (washer) side of the weld nut and to the trough where the weld nut is installed.
-
Install the new component or components.
- Clamp the weld nut into position, and wait until the structural adhesive is fully cured (refer to the adhesive manufacturer's instructions).
- Once the structural adhesive has cured, remove the bolt from the weld nut.
- Use KIT, METRIC THREAD RESTORING (Tesla part number 1082418-00-A) to chase the threads of the weld nut until no adhesive is present.
- Perform any necessary post-repair operations.
- Install the Ball Stud - Liftgate - Body Side - Pair (Remove and Replace).