Wiper Bracket (Outboard)
Correction code:
10101026702,
10101026802
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | WIPER BRKT O/B (Wiper Bracket – Outboard) | |
| 2 | Structural Bulb Rivet, 6.5 mm | |
| 2 | Flow Form Rivet S08 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Windshield (HW4) (Remove and Replace).
- Remove the Underhood Storage Unit (Remove and Replace).
- Remove the Vehicle HV Disablement Procedure.
- Remove the Reservoir - Windshield Washer (Remove and Replace).
- Remove the Electromechanical Brake Booster Assembly (Non-Structural Pack) (LHD) (Remove & Replace).
-
Remove the original component.
- or Factory Spot Welds
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
- Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Electromechanical Brake Booster Assembly (Non-Structural Pack) (LHD) (Remove & Replace).
- Install the Reservoir - Windshield Washer (Remove and Replace).
- Install the Vehicle HV Disablement Procedure.
- Install the Underhood Storage Unit (Remove and Replace).
- Install the Windshield (HW4) (Remove and Replace).