03/07/2024 16:07:51

Lamp Housing Assembly (Vehicles Built Through February 17, 2022)

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	LAMP HOUSING ASSEMBLY THROUGH FEB 17 2022 LH (Lamp Housing Assembly - LH)
1	LAMP HOUSING ASSEMBLY THROUGH FEB 17 2022 RH (Lamp Housing Assembly - RH)
10	Structural Bulb Rivet, 6.5 mm
3	Flow Form Rivet S18
2	Flow Form Rivet S28

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the necessary portion of the Quarter Outer Skin (Vehicles Built Through February 17, 2022).
Remove the original component.
or Factory Spot Welds
or Drill through factory spot welds
Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
Prepare for installation.

Note
A red X indicates a location where a factory-installed fastener is not being replaced.

or Structural Bulb Rivets, 6.5 mm

or Flow Form Rivets, S18

or Flow Form Rivets, S28
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the necessary portion of the Quarter Outer Skin (Vehicles Built Through February 17, 2022).
Perform any necessary post-repair operations.