前排座位塔
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | M3 ASY, SHOTGUN TOWER（前排座位塔） |
|
| 17 |
High Strength Structural Rivet, 6.5 mm
|
|
| 1 |
Flow Form Rivet S18
|
|
| 2 |
Flow Form Rivet S38
|
|
| 1 |
Flow Form Rivet S48
|
|
| 1 |
Bolt
，M8x23.5 |
Tesla 零件号 1063260-00。 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
Factory Spot Weld
-
Prepare for installation.
High Strength Structural Rivet, 6.5 mm
Steel Plug Weld
注在每个塞焊安装位置钻一个 10 毫米的孔。
Installation Spot Weld
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
注将螺栓拧紧至 35 Nm。
-
Perform resistance spot
welding.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
-
Plug weld the steel areas.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
-
安装新挡泥板和车灯支架。
- Perform any necessary post-repair operations.
