2024-07-10
B 柱外件总成(完整)
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | B 柱外件总成 |
![]() |
33 |
![]() |
注 所要安装的铆钉数量取决于清除的焊缝数。 |
Repair Procedure
- 拆下车身侧外件总成的必要部分,以便露出下方所要更换的组件。
- Remove the original component.
-
Prepare for installation.
or
High Strength Structural Rivets, 6.5 mm
注安装底排铆钉,各铆钉中心应位于组件底边缘的指定高度。- A = 15 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform resistance spot
welding.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
- 安装为露出所要更换的组件而被拆下的车身侧外件总成部分。
- Perform any necessary post-repair operations.