2024-07-17

门槛外件(后部)

Parts List

Quantity Description Image / Notes
1 M3 PNL - SILL OUTER REAR(后门槛外件)
11 Structural Bulb Rivet, 6.5 mm
1 High Strength Structural Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. 拆下C 柱加固件下部。
  2. Remove the original component.

    Factory Spot Weld

    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  3. Prepare for installation.

    Installation Spot Weld

    Structural Bulb Rivet, 6.5 mm

    High Strength Structural Rivet, 6.5 mm
    • A = 13 mm
    • B = 67 mm
    • C = 19 mm
    • D = 9 mm
  4. 在车辆的接合面和新组件上涂抹结构型粘合剂
  5. Install the new component or components.
  6. Perform resistance spot welding.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  7. 安装C 柱加固件下部。
  8. Perform any necessary post-repair operations.