2024-11-22

A 柱外件加固板(部分)

Repair Procedure

  1. 拆下车身侧外件总成的必要部分,以便露出下方所要更换的组件。
  2. 拆下前排座位外侧
  3. Cut the original component at the indicated locations.

    Cut Line

    Reference Line/Point

    • A = 75 mm
  4. Remove the original component.

    Factory Spot Weld

    Factory Spot Weld Area

  5. 按图所示切割新组件,以便制作衬垫板。
    Cut Line
    • A = 120 mm
  6. 准备安装衬垫板

    High Strength Structural Rivet, 6.5 mm

    Informational PurposesAn informational icon, calling your attention
    在面板的顶面安装两颗铆钉,然后再在每个成角度的侧面各安装两颗铆钉。使顶部铆钉位置偏离侧面铆钉,以免干扰安装。
  7. 在车辆和衬垫板之间的接合面上涂抹结构型粘合剂
  8. 安装衬垫板。
  9. Prepare for installation.

    Installation Spot Weld Area

    High Strength Structural Rivet, 6.5 mm

    Structural Countersunk Rivet, 6.5 mm

    Bolt
    Informational PurposesAn informational icon, calling your attention
    重新使用从铰链柱和前行李箱盖铰链区域拆下的螺栓固定新组件,直到结构型粘合剂完全固化。
  10. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  11. Apply a bead of urethane sealant to the foam dam edges.
  12. Install the new component or components.
  13. Perform resistance spot welding.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  14. 安装新前排座位外侧
  15. 安装先前为露出更换组件而拆下的车身侧外件总成部分。
  16. Perform any necessary post-repair operations.