后车身面板

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	M3 ASY, REAR PANEL COMP（后车身面板）
23	Structural Bulb Rivet, 6.5 mm	注所需铆钉的数量可能因维修区域的连接点数量而异。
2	Flow Form Rivet S18
6	Bolt , ,HF,M10-1.5x35,[109],ZNFL,SMAT	Tesla 零件号 1044009-00-A。
6	螺母，HF M10 PC10	Tesla 零件号 1047337-00-A。

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the original component.

or Factory Spot Welds
注
部分车辆在某些位置有 SPR，而非点焊焊缝。

or Drill through factory spot welds
注
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.

or Factory SPRs

Stud
Prepare for installation.

注
A red X indicates a location where a factory-installed fastener is not being replaced.

or Structural Bulb Rivets, 6.5 mm
注
确保突出显示区域的铆钉连接上所有底层面板。

or Flow Form Rivets, S18

Bolt
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
将这些螺栓拧紧至 60 Nm。
Perform any necessary post-repair operations.