2024-07-10

后副框架支座

Repair Procedure

  1. 按照指示位置切割底板,然后向后弯折制作翻门(红色所示),使其足够大,以便清除点焊焊缝(位于翻门下方)。

    Cut Line

    Reference Line/Point

    • A = 20 毫米
  2. 拆下原装组件的外侧部分
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  3. 拆下原装组件的内侧部分
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  4. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Installation Spot Welds

    or Structural Bulb Rivets, 6.5 mm
    • B = 6 毫米
    Informational PurposesAn informational icon, calling your attention
    将底板翻门(红色所示)恢复原始位置,然后安装以红色圈示的结构型灯笼铆钉。
  5. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
    Informational PurposesAn informational icon, calling your attention
    向之前制作的底板翻门的顶部涂抹少量的结构型粘合剂。
  6. 将底板翻门(红色所示)折回原始位置。
  7. Install the new component or components.
    Informational PurposesAn informational icon, calling your attention
    将底板翻门(红色所示)恢复原始位置,然后安装以红色圈示的结构型灯笼铆钉。
  8. Perform resistance spot welding.
    or Installation Spot Welds
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  9. Perform any necessary post-repair operations.