车架前纵梁外件（整体）
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | 前纵梁外件总成（车架前纵梁外件） |
|
| 26 |
High Strength Structural Rivet, 6.5 mm
|
|
| 1 | 焊接螺栓，DAW，M6x18，STL[88]，ZN，SD | Tesla 零件号 1129607-00-A。 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
拆卸扭矩盒盖总成。
-
拆卸前排座位剪力壁。
-
Remove the original component.
Factory Spot Weld
Factory Spot Weld Area
- 清除所有泡沫。
- Remove any remaining adhesive from the mating surfaces of the vehicle.
- Perform any necessary post-repair operations.
Replacement
-
Prepare for installation.
Installation Spot Weld
Installation Spot Weld Area
注确保制动踏板已移开。
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform resistance spot
welding.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
-
安装新前排座位剪力壁。
-
安装新扭矩盒盖总成。
-
安装紧固件，将扭矩盒盖总成固定到车架前纵梁外件。
High Strength Structural Rivet, 6.5 mm
- A = 64 毫米
- B = 49 毫米
- C = 7 毫米
-
按指示做好焊接螺栓安装准备。
Stud
- E = 20 毫米。
- F = 20 毫米。
GMA Weld
-
Perform GMA welding.
GMA Weld
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.注Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.