2025-03-09

上侧梁内件加长板

Repair Procedure

  1. 拆下车身侧外件总成的必要部分,以便露出下方所要更换的组件。
  2. 拆下车顶纵梁加长板
  3. Remove the original component.
    or Factory Spot Welds

    or Factory SPRs

    Informational PurposesAn informational icon, calling your attention
    重新安装车身侧外件总成的相应区块后,需要在红圈处安装一颗 S38 流型铆钉。
  4. Prepare for installation.

    or Installation Spot Welds

    or Structural Flange Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short
    • Reference Line/Point
    • A = 22 毫米
    • B = 15 毫米
    • C = 10 毫米
    • D = 5 毫米
    Informational PurposesAn informational icon, calling your attention
    在拆下原厂 SPR 的孔的两侧安装沉头铆钉。
  5. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  6. Install the new component or components.
  7. Perform resistance spot welding.
    • or Installation Spot Welds
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  8. 安装车顶纵梁加长板
  9. 安装先前为露出更换组件而拆下的车身侧外件总成部分。
  10. Install the fastener as indicated.
  11. Perform any necessary post-repair operations.