2024-07-17
后车架纵梁（上部）
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | Asy-Rail Rr Upr（后车架纵梁 – 上部） |
|
| 24 |
High Strength Structural Rivet, 6.5 mm
|
|
| 2 |
Bolt
，SEMS,[FL],HX,M8x23.5 |
Tesla 零件号 1063260-00。 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
拆卸 后车身面板。
-
拆卸后车架纵梁端板。
-
Remove the original component.
or 
Factory Spot Welds
or 
Factory SPRs
注红圈标注的原厂 SPR 隐藏在横梁后侧，必须从车架纵梁内侧进行打磨。研磨 SPR 时，只需将 SPR 研磨至足够拆下组件的程度；不要将 SPR 从接头上完全拆下。安装新的后纵梁上部时，不会更换这些铆钉，这些 SPR 的剩余部分留在接头中，以保持与内侧隔板的某种机械连接。
or Bolts
-
Prepare for installation.
注A red X indicates a location where a factory-installed fastener is not being replaced.
or High Strength Structural Rivets, 6.5 mm
- A = 40 毫米。
- B = 26 毫米。
- C = 64 毫米。
- D = 147 毫米。
- E = 56 毫米。
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
将这些螺栓拧紧至 24 Nm。
-
安装 后车身面板。
-
安装后车架纵梁端板。
- Perform any necessary post-repair operations.