2025-06-27

前顶加固板连接器

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds
  2. Put the new component into position and clamp it into place.
    Informational PurposesAn informational icon, calling your attention
    将新组件按所示放置,并借助各顶部加固板下部的饰板孔将其夹紧入位。
    • A = 1263 mm
  3. Prepare for installation.
  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
  6. 执行电阻点焊
    or Installation Spot Welds
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  7. Perform any necessary post-repair operations.