2024-07-17

铰链柱(整体)

Repair Procedure

  1. 拆卸 A 柱外件加固板(区块)
  2. Remove the original component.

    or Factory Spot Welds

  3. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    为要穿过门槛外件安装的每个铆钉钻一个 6.7 毫米的孔,该孔要同时穿过门槛外件门槛插件的顶部。这些孔可以为门槛外件区块使用的铆钉提供间隙。
    or High Strength Structural Rivets, 6.5 mm
    Informational PurposesAn informational icon, calling your attention
    底排结构型铆钉上所有铆钉的中心必须距离新组件下边缘指定的高度,如下所示。
    • A = 15 mm

    or Structural Bulb Rivets, 6.5 mm

    or Structural Countersunk Rivets, 6.5 mm

    or Installation Spot Welds

  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
  6. Perform resistance spot welding.

    or Installation Spot Welds

    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  7. 安装新 A 柱外件加固板(区块)
  8. Perform any necessary post-repair operations.